Chemistry quantum numbers?

Best biological safety cabinets https://aresscientific.com...Show more

those wavelengths correspond to the "paschen" series for hydrogen atoms.
https://en.wikipedia.org/wiki/Hydrogen_spectral_series

n initial.. ... n final .. . .  λ (nm)
... 4.. ... .. .. . .3. .. ... .. . 1875 
.. .5. ... .. ... .. 3. .. .. .. .  1282
.. .6.. .. .. .. .. .3. .. .. .. .. 1094
.. .7. ... .. .. .. .3.. .. .. . .. 1005
.. .8. .. .. .. .. ..3. .. ... .. ... 954.6
. ..∞. .. .. ... ...3. .. .. .. .. .. 820.4

those values can be calculated via the rydberg equation
https://en.wikipedia.org/wiki/Rydberg_formula
with Rh = 1.097x10^7 / m...Show more

First, this question makes no sense because it does not say what kind of atom these electrons are attached to.  Since hydrogen is used most commonly in school problems, we could assume hydrogen, but it would be better if the question said so explicitly.

Whether the initial n is greater or less than the final n depends on whether the given wavelength is emitted or absorbed, respectively.  The question does not say anything about that either.

Next, I see no way to calculate the answers without using the Rydberg equation and every possible combination of integers taken two at a time to calculate wavelengths, which would consume an absurd amount of time.

The remaining possibility is to look at the various hydrogen spectrum series, and hope to find matching wavelength values.  The source below gives many possibilities.  The near matches I find there are:

954.60 nm  (3 and 8)

1004.94 nm  (3 and 7)

1093.81 nm  (3 and 6)

1875.10nm  (3 and 4)...Show more

delta E  =  hc/L   >>>  I am using L for lambda (wave length)
delta E =  (6.623x10^-34)(3.00x10^8)/(954.60x10^-9)
  / / / / use a calcilator
 / / / hopeflly you have a table somewhere with energies of each emergy level ... n= 1 and n = 2 and ///etc
 / / / subtract then and get the delta E answer above...Show more

First off, a cheat sheet:

https://upload.wikimedia.org/wikipedia/commons/thumb/b/b2/Hydrogen_transitions.svg/600px-Hydrogen_transitions.svg.png

Look at the 1875.10 value on the image. You'll see that it involves a change from 4 to 3 (for emission) or 3 to 4 (for absorption).

Now, how do you figure out the values without the cheat sheet?

Answer: you have to use the Rydberg equation and try different n_i and n_f values. One point is that the wavelengths are all infrared, so relatively little energy is involved. That immediately eliminates n = 1 since those lines are all ultraviolet. n = 2 is gone since those values are visible to ultraviolet. So, start looking at n = 3.

Make sure to do a couple calculations to make sure you know how to use the Rydberg Equation. Here's an example:

https://byjus.com/rydberg-formula/...Show more