chris b

Been told the bandit 1200 and gsxr1100 motor will fit straight in with minor changes. But would a gsx1100f be a straight forward swap. I notice the gsxf used the 34mm makuni but the gsx750w uses the keihin 34mm carb but would coils, cdi and mounts be the same? 

I have a galaxy s5 and I downloaded mp3 s and they worked fine and then I transfered them to a new memory card on my phone and still worked but the next day none of the files will play. I have tried a different music player app from the play store but still won t play. Any ideas how I can get them to work?

Just passed my lgv and hgv and Adr and started a new tanker driver job. Question is would anyone have a list as requirements to what needs to be carried whole on the road, i know about ppe and adr card, Un number ect but some people are telling me i need bucket. Shovel, brush and a load more document s that have not been given by the company like empty but dirty placard. I ve asked at work and some say I need them and some say I don t. Is there a site to list everything I need to carry while under Adr so I know exactly where I stand and I don t get caught out

I have a gpz500, it was laid over for possibly an hour the other day, I put it back up and tried to start it. It wouldn t fire up and back fired when ever I gave it a little throttle. The carbs have oil I m and the engine has oil and petrol in it. Is this just because it was laid down or could it be something else. Also will it be okay if I drain oil and flush engine out with oil. Clean carbs and plugs and then try fire it up?

I have a 05 platell ford ka, it has no central locking. Single cable locking system. Can I fit a remote central locking system to it?

I've just got a 05 plate ford ka. Duratek engine and when driving the wheel is pUllingswick to the left then to the right, almost like a wobble but not as fast and when I go to turn corners I feel it resisting more that it should and the power steering feels a lot heavier than my last ka

It doesn't really get any worse with speed and doesn't change under breaking either

Been told it could be track rod ends but had them checked and they are fine for now. Any ideas what it could be

I have a kx450f and it s off road atm but looking at putting it on road with a daytime mot. I have a led brake light and I ve wired it up to a small battery and it works fine but obviously I d have to take the battery off now and again to charge it. Will this be okay for road use or will I have to changed the stator ect and run it through the bike so it s always charged?

I'm going to take a look at a rs125 over the weekend as a project. The owner has said to me it cut out one day as if it ran out of fuel, he said the rac man checked spark and it was strong, the starter button has stopped working. He also said the engine had full rebuild last year.

To me this sounds like the carb is blocked or no fuel but I've been told that the top end goes alot on these bikes. Does it sound like it could be top end or engine fault or fueling?

I have a N reg Zl600 and the clutch is constantly biting, I've changed the cable and adjusted it as far as it'll go but still biting, I've never changed a clutch before on a bike and want to try it myself. Will I need new springs or plates or both?

Thanks

My gpz500s won't start off the button. The solenoid is clicking, I replaced it and still clicking, I've tried shorting the solenoid with a screwdriver but it's not turning starter motor, I've had the starter motor off and cleaned so I can rule that out. Could it be a faulty solenoid still?

I can bump the bike off fine and battery is charged and holding good voltage

I know some bike parts are interchangeable and before I buy one for the 535 I though I could find one cheaper that will still worked on the 535

I have a sym euro x 50cc on a 60 plate. I have changed the plug, had the carb stripped down and cleaned, chamged, cap ht lead, coil and not even trying to fire up. Ive tried putting a bit of petrol down the sparkplug hole to see if it would attempt to fire but it wont.

ive bought two new cdi units and both dont send a spark but the old one does which i am confused about unless both new cdi units happen to be broke?

any other ideas as what it could be?

Im new to growing plants and i would like to grow some habaneros in my room, ive made a small set up that has a 6watt purple cree bulb wired to a battery, i kmow its a small wattage but the beam that comes from thebulb is really bright. Would this give sufficient light to grow the habanero

if it isnt what would you recommend or make using single leds or smds? ( on a bugdet ) or what wattage and colours should be used to get the best results

thanks

I have a sym euro x 50cc 2010 and the engine is buggered and i thought id ask if anyone knew of the top of there heads what engines fit into the frame, could it be possible that the frame for chinese and Taiwanese scooter are generally the same and most engines would fit or would i have to sort out and find a sym euro x engine

It s a dominator headlight but has poor 35w bulbs in that look like some sort of bay15d bulbs

Not fully sure if it would work but can you vacuum form an existing seat unit to make a second one or would I need to make a mold and vacuum form that?

Not tried vacuum forming before