boardguy2008

replace knock sensor and wire with the inulated wire the toyota requires and the code still there

is driving me f.... crazy

i follow the wire from the ecu and looks fine but the code still there

please help

i have a problem with my engine , a code saying that the fuel is lean

i want to know what the fuel pressure should be on my truck

replace

rotors

bearings

spindle

brake pads

tie rods

change the two tires for new ones

did balance

alingment

and the crap still vibrates

feels on the driver side

please help

maybe the vibration is coming from somewhere else??

i have a 2000 ford truck E250 3/4 ton Van 5.4L EFI 8cyl

last night the air bag light just turn on and i have no idea what may be going on

does anybody have an idea why is this

some kind of sensor faulty ??

where??

thanks for you help

put on drive it wont stall but the RPM's are very low

any advise on what to check?

engine block

my engine block broke pretty bad on the bottom

i already got another block and im putting everything from my broken one to the one i buy

my question is

DO I REALLY HAVE TO DO ANY WORK ON THE CYLYNDER HEADS???

they did not overheat and anything like that

the block broke cause i hit a bump very hard mi car is very low

hi

i need to buy an engine block for a 1998 honda accord 3.0 vtec 6cyl

please any word on where to may be possible to get this

only need the block

2001 land rover range rover 4.0

service engine light came on but im not sure if this scanner will work

any advice

replacing a radiator and a high pressure power steering line on a 200 jeep cherokee 4.0

is this a good price for labor??

have a 87 chevy astro 4.3 tbi that wont read the temp

the gauge on the cluster stays low all the time

i replace the temp switch and

temp sensor

and still the same

i ground the wire going to the temp switch and the gauge goes all the way up wich means the gauge works

but when i put the wire to the sensor it just wont read the temp

any ideas

i have a 93 plymouth voyager 3.3

this past weeks the fuel gauge its been acting weird

when i fill the tank the gauge always says that its 3/4 full and i use the car for a week and it wont move

is it possible to fix the sending unit???

or its f- up and i have to replace the whole pump and sending unit

pump works fine

valve is working

87 chevy astro van 4.3 TBI automatic

i disconected while the engine is idleing and it does not make any difference, does this mean is not working

engine idles the same with or without it

help

thanks

a 99 chevy astro van

my rear tires are hitting the body and i want to lift it up a couple of inches

if it is even possible doing it to this van

DOHC

TBI

SFI

EFI

MFI

SFI DOHC

FI

MFI DOHC

advance on a 87 chevy astro van 4.3 automatic

i need to adjust timing but need to where is this connector

electronic advance conector

87 chevy astro van 4.3 automatic

i need to adjust timing but theres no rpms gauge on the cluster so i have no idea where to start ,i can adjust the throttle so it idles faster but since theres no rpm measure its kind of complicated

way to the red line when engine cold and stays below 100 degrees when the engine its already hot

does this mean that my coolant temp sensor is bad??

87 chevy astro 4.3 automatic 6cyl

i have a 87 chevy astro van automatic with a carburator

i need to know if this part on the picture is a carb ??

my problem is that i can't get this car to start when its cold, i read that it may have a faulty choke but theres no choke in it

if you can see the picture can you please tell me where the choke is

or why my van its not starting when cold

once it starts one time it will start fine as long the engine is warm

http://s1215.photobucket.com/albums/cc520/boardguy...

i have a 87 chevy astro van 4.3 automatic with carburator

it has problem to start when cold ,i read that i may have a faulty choke and i try to located but i can find it

theres no part on the carb that looks like a choke nor around it

the only thing that was connected to the carb with a metal rod was the cruise control servo

does this part does the work of a choke or are different pieces????

honda accord 92

where the pointer should be??