Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.

Lv 1237 points

josh_man22

Favorite Answers31%
Answers19

  • Why does my airbag light come on in my 2004 Pontiac Grand Am GT?

    It comes on for 30 seconds at a time then off and so on.

    It still runs and shifts fine while this happens.

    Any Ideas?

    1 AnswerMaintenance & Repairs1 decade ago

  • How many cubic inches will this be?

    I have a 1978 chevy 350ci "10" block bored .060 over. If I put a 400 crank in it with 3.480 stroke and 5.700 rods, +5.00cc flat top pistons, and 64cc Pro Comp 210 heads,.........What will my actual cubic inches and aproximate HP be??? And will this make it a "Stroker"?

    Please no BS answers, I am trying to build a MONSTER!

    All tips and info are greatly appreciated.

    1 AnswerOther - Cars & Transportation1 decade ago

  • What are my cubic inches?

    I have a 1978 chevy 350ci "10" block bored .060 over. If I put a 400 crank in it with 3.480 stroke and 5.700 rods, +5.00cc flat top pistons, and 64cc Pro Comp 210 heads,.........What will my actual cubic inches and aproximate HP be??? And will this make it a "Stroker"?

    Please no BS answers, I am trying to build a MONSTER!

    All tips and info are greatly appreciated.

    2 AnswersMaintenance & Repairs1 decade ago

  • Stroker or not????????

    I have a 1978 chevy 350ci "10" block bored .060 over. If I put a 400 crank in it with 3.480 stroke and 5.700 rods, flat top pistons, and 64cc Pro Comp 210 heads,.........What will my actual cubic inches and aproximate HP be??? And will this make it a "Stroker"?

    Please no BS answers, I am trying to build a MONSTER!

    All tips and info are greatly appreciated.

    1 AnswerMaintenance & Repairs1 decade ago

  • What internals and heads should I use?

    I have a 1978 GM 350ci freshly bored .060 over and honed. I will be using a Weiand dual quad High-Ram Tunnel Ram with an RPM Range of 2,800-8,000

    Note: I would like to acheive at LEAST 400 RWHP

    1 AnswerMaintenance & Repairs1 decade ago

  • Whats the cheapest way to get 400+hp out of a '78 GM 360?

    I am on a tight budget and I want 400-450 hp out of a GM 350 bored .060 over, honed and decked. I will also be running a dual quad "Air Gap" intake with two 600 cfm carbs. I will be putting a stroker crank in it as well. Trans is a THM-350 with a 2500 stall conv.

    and 4.10 gears in the rear. The heads will more than likely be a set of Edelbrock aluminum 2.02 1.6 64cc with KB flat top pistons

    Question being, what other parts should I use to achieve my goal??

    Please, don't tell me nitrous!

    5 AnswersChevrolet1 decade ago