formulafire83

Ok so i want to get rid of the d15b2 engine that my car currently has, and i want to replace it with a d15b jdm vtec engine from 92-95. Has anyone done this swap and if so what is needed to complete the swap?I know i need to modify the engine harness, do i need the connectors from another harness meant for the jdm engine, which ones? And will i need to block off anything or will i need any new sensors since I will be converting to an OBD1 p28 ecu? Let me know if you can help I am only looking for experienced advice, thanks.

Ok so i want to get rid of the d15b2 engine that my car currently has, and i want to replace it with a d15b jdm vtec engine from 92-95. Has anyone done this swap and if so what is needed to complete the swap?I know i need to modify the engine harness, do i need the connectors from another harness meant for the jdm engine, which ones? And will i need to block off anything or will i need any new sensors since I will be converting to an OBD1 p28 ecu? Let me know if you can help I am only looking for experienced advice, thanks.

I have a 1988 honda civic dx hb 5-spd trans, the d15b2 engine it has is shot and i want to replace it with its jdm counterpart d15b, will the trans hook right up?

Fuel pressure is fine , not getting spark to plugs, coil is fine. Definitley a spark issue. Was running good then i went inside for a bit, came out side wont start, battery is good, starter is good, just had tune up (1 month ago)- plugs,wires, cap, rotor, new altenator, belt. I think it is something in the distributor, can anyone knowledgible help plz.