?

This actually pertains to my snowblower but figured nonetheless an engine is an engine. I did a tune up on it last week and when I changed the oil it was filthy....Which brought me to my question. Is it necessary or beneficial at all to change the oil one more time? Or is that in essence a waste of time and dollars? Thanks for offering your insights.

Ok..First off I feel like a donkey...I have a 07 3.5 Altima that requires premium gas and I've been putting in regular for at least a year and a half.....Sometimes ill hear a slight knock...now I know why..I have about an 1/8th of a tank left..Should I just add premium now or wait until the regular is almost out to refill with the premium...And do you think I caused any significant damge?..thanks in advance

Thanks for reading. I'm going to re wire a guitar I have. The problem is I'm not sure which kind of pots to get i.e..250k or 500k.

The guitar is a knock off strat with only two single coil pick ups, at the bridge, and, at the neck. It has one volume control and one tone control. Could somebody perhaps tell what pots would be in my best interest for this setup? I lack a multi-meter at the moment. I heard 250k is usually used for single coil but was wondering maybe 500k since there is only one knob for each....This is where I'm kind of lost. As always thanks.

Just like it sounds. Will boiling water reduce it parts per million? What exactly will boiling the water remove? That is, from tap water. Thanks.

What size do I use with G scale trains? Is it 1/32 or 1/24? Thanks.

Just wondering...Can I plug the L and R of my keyboard into two channel inserts on my mixer??? I wanna use the EQ....And if so...Do I pan the left channel hard L and the right channel hard right??? Thanks for your time.

Thanks for reading. Can Kinect take profile and gamer pics? Or just games and video chat? Thanks again.

Trying to figure out WTF??? The game will randomly freeze. Take for ever loading while roaming the world. Also, after I beat the kill the bandit cheif quest I'd get on my horse only ti be invisible. Shortly after the game stopped loading and the sound ceased. The xbox is the new slim 4GB less than two weeks old. So is it most likely the game or the xbox???...Thanks for reading

I have a problem. My front two speakers in my car are wired parallel (how it came factory). The dash one is 2 ohms (stock) and my door one is 4 ohms (replacement) for a load of 1.33 ohms or something of that nature. My headunit says only loads of 4 ohms to 8 ohms should be used. My question is, if I disconnect the 2 ohm dash speaker that was wired in parallel with the 4 ohm speaker, will my load drop to a stable 4 ohm load? Thanks for reading.

Sorry for the dumb question I just wanna know if I can run this amp like this. I have 2 SVC subs in a box. I wanna take both positives and put them on the left side, then I wanna take the two negatives and connect to the right side...(bridging)?....but I dont know if I can do it....This is what the amp says..

"This amplifier is designed to operate with a minimum of 2 ohms in stereo. 4 ohms in mono or 8 ohm in multi mode configurations."

So can I connect them the way I stated above? Again thanks and please excuse the ignorance.

I'm gonna be replacing the stock speakers in my 07 Altima non-bose car...I know the speakers are 2 ohms...would these speakers be a good replacement for them?..They are the only 2 ohm speakers I can find..

http://www.woofersetc.com/p-7175-cx62-v2-image-dyn...

Thanks for reading and offering your insights.

I'm getting ready to paint my diecast car... The vehicle is white and will be adding black to it. My question is, When "roughing" up the clear where im gonna paint, what grit should I use? The ONLY thing I have available is some #00 steel wool, some 2000 grit paper, some 1500 grit paper, and some other stuff which I'm not sure of, it says P150 and 330U on the back...Never saw two numbers before. Thanks for taking the time to read and offer your insights.

Hello...Thanks for reading. Im gonna be painting a white diecast model. My question is, can I use 1500 grit to rough up the clear coat...The model is white...gonna paint it black..And all I have is the 1500 grit..So could I get by with it, or do I need something a bit more course? Thanks

Whats up everyone. I have a TM G17. How do I adjust the hop-up for more hop? I can't to seem to figure which way I have to turn it. Also, How many clicks, or, how far is it able to be turned> I don't wanna ruin it and this is the first airsoft gun I have had. Thanks for reading.

Making something for my destructoid and was wondering what dollhouse scale is best suitable for use with a 1:18 model automobile? Thanks for your time.

Just wondering. Just a novice in electronics. Are all 555 IC chips the same? For instance will a chip that is named 555CN operate the same as a chip named LM555 or yet another named TLC555. If you could also explain the differences or perhaps point to something that could help in explaining it. Thanks for reading.

Just wondering. Just a novice in electronics. Are all 555 IC chips the same? For instance will a chip that is named 555CN operate the same as a chip named LM555 or yet another named TLC555. If you could also explain the differences or perhaps point to something that could help in explaining it. Thanks for reading.

I am doing some research regarding cannabis laws in Wisconsin. I know Wisconsin is not a medical use state. Which according to the will of the people it should be. But that's another forum. My question being. If I was prescribed medical marijuana in another state i.e..California, Michigan or wherever. Could I be excused from prosecution? I know that federally the law still regards anything to do with cannabis illegal. And that under federal guidelines I know I could still be prosecuted. I ask this questions because I was reviewing Section 961.41 (3g) of Wisconsin Law. Here's what the text says:

Section 961.41 (3g) governs possession of controlled substances. It was

not amended in 2008.

961.41(3g)

(3g) Possession. No person may possess or attempt to possess a

controlled substance or a controlled substance analog unless the person

obtains the substance or the analog directly from, or pursuant to a

valid prescription or order of, a practitioner who is acting in the

course of his or her professional practice, or unless the person is

otherwise authorized by this chapter to possess the substance or the

analog. Any person who violates this subsection is subject to the

following penalties:

So, in a nutshell. Will the wording of this text be a viable defense if I have a MEDICAL MARIJUANA CARD from another state and exercise my medical use in Wisconsin and something was to happen? Thanks for your help in regards to this matter.

What kind of screwdriver is this...Its a flat head with a plastic tube with a spring at the end and two prongs that protrude when the spring is pulled back...what is the name of this type of screwdriver...and what is it used for...thanks...

who was the guest tonight...it was a rapper...anyone know it was....thanks