Chunk

i have a gs750e with pod filters and a 4 into 1 exhaust and i want to get some advice on jet sizes for the carbs, because in third gear it will not pull more 5500rpm and loses more as i shift but speed stays the same.

thanks

The transmission was rebuilt and so was the t-case but the trans witch is the 47RH. Its like it sticks in between gears, I thought maybe a vacuum leak because the 4wd doesn't work either?

so maybe they are related?

I have a 1972 Sportster that only will run on 1 cylinder. It has new mechanical advance because of a broken spring, new coil because of Primary resistance was too high and plugs, wires, But it will only run on one cylinder and i switch the wires and it follows the switched wires. its a dual fire system and a XLCH 1000.

How would I tell the difference between a dodge HT-361 and a HT-413 engine used in medium duty trucks? I'd like any and all info i can get.

i have a 78 gs750e that i am putting rings in and i was wondering if anyone knows if the bottom of the cylinders are tapered, like some dirt bikes so i don't have to use a ring compressor?

i have an older Suzuki and would like get a little more power out of it does anyone know of a website where i can get some but i still need it street-able.

i found one for a decent price and was wondering is there any problems that they are know for because my dad's 1976 huski 45cc is a great saw i was wanting something like it for a birthday present for him cause that old saw is getting harder for him to lift

what is the difference between 340 j cast and 340 x cast heads and which would be better for power and street use?

i would like to pull my gs down and do the gaskets and pistons and rings but the only piston set i found was from 748 cc actual to 844 cc isn't that too much without replacing cylinders and or putting sleeves in the cylinders?

how reliable would 1976 dodge power wagon 440 automatic be?

i have already rebuilt the carburetors completely only way to stop gas from spilling out is clamp fuel line with vice gripes. fuel valve maybe?

does any one know how rare a 1998 dodge ram 1500 SS/T 4x4 is?

already replaced the points and condensers new k&n filters probably carbs though

wont pull pass eight in fourth thinkin it may be valve timin or carbs?

the bike has already been jetted and synchronized gas flow is good from tank just it wont rev. passed five grand starts and idles great and will rev when in neutral but put it first and get going it spits out the carburetors and not enough power to go seventy

hi, i own a '78 Suzuki and was told it was a gs1000e but i keep finding 750 on it is there a site that will decode my Vin. for free?

would a '88 w150 be a posi/sure-grip rear end or differential? its a 4x4 318 automatic

OK first of all their are clutches in a automatic transmission, and I'm taking out the v6 and dropping in a 318 would like to know what it takes to get the transmission to handle the v8