pressure washer hose leaking?
I have a Troy-Bilt pressure washer and the pressure hose has a leak about the size of a pin hole.. any fixes or will I need to get a new hose?? thank you
I have a Troy-Bilt pressure washer and the pressure hose has a leak about the size of a pin hole.. any fixes or will I need to get a new hose?? thank you
Pat
Favorite Answer
The leak will intensify. a temporary fix one can use is go to your home depot wal mart or lowes and get a spray can of leak stop. spray it on the pin hole allow to dry and use either duct tape or electrical tape and tightly wrap several wraps over the hole. Eventually though you will more than likely have to replace the hose.
stephaine
That you can repair it like plumbers or steamfitters do. It is referred to as a bandaid. Relying on how enormous the gap is, this can also be so simple as a bit of rubber and a screw form hose clamp. Cut a section of rubber ( old innertube ) just colossal ample to duvet the gap and place the hose clamp over the patch and tighten. If the hole is just too huge , simply change the hose. There are commercial bandaids on hand but the cost would no longer be worth it. They are ordinarily utilized in places the place you're speaking about better more steeply-priced traces or they're used for temp. Repairs, I've even used these on the hydraulic lines on my dozer.
big fella
Get a new one,there is nothing you can do to seal the hose.Possible injury could happen if if blew apart.