the drag dial on the back of my fishing reel wont turn?
the dial on the back of my fishing reel that sets how much line can be taken by a fish wont turn? what is wrong with it?
the dial on the back of my fishing reel that sets how much line can be taken by a fish wont turn? what is wrong with it?
?
Favorite Answer
This may sound stupid....but take your reel off the rod and lay it in a pan or small bucket of lukewarm water for about 5 minutes....then shake off water and remove all parts to let water drain then dry....the drag dial should be working again....most likely a collection of dirt and debris clogging it up so it does not turn...........
paul z
It could be seized up,try lubricating the underside of the knob,where it is attached to the reel,and manually turn the spool to free it up.there's probably some dirt or grit that's accumulated on the washers and keeping it from moving.Worst case scenario,take the screw out,and disassemble it,clean it all out thoroughly,then re-assemble it exactly reverse of the way you took it apart,the washers have to go back in the same configuration as original,or it won't function properly.If any of the washers are worn out,or damaged,you'll have to get new ones and replace them before it will work right again.
?
youve likely killed it the two you have broken the flexibility header and its snapped off or you have broken the hard drive previous fix in basic terms thank you to restoration it is getting a sparkling hard drive and os this might value you approximately one hundred fifty funds to change simply by desiring a sparkling working equipment besides