brigges & stratton 407777 type 0167-E1 HAVING TROUBLE WITH PUSH ROD bending any ideas?

Jim W2013-07-08T15:19:24Z

Favorite Answer

Consult the service and maintenance manual for that engine. This should give rod specifications and the valve clearances. The rod could be the wrong size or the wrong material or the engine may have other problems.

00

?2013-07-08T13:20:37Z

Valve clearance, it is only made of aluminum and will bend if too tight, usually when the temperature rises.

00

Related Questions

Do You Have A Gloomy Or Sunny Bent By Nature?i have a 1948 Farmall H tractor and one of the push rods is bent is it okay to put it in bent?I have a push lawnmore it is a Briggs & Stratton 4.0 HP I am having trouble getting it started?Poll: Have you ever passed out in public?Do certain last names in your area give you ideas about a family's social status, race, or anything else?

Trending Questions

How much more power does a 10 amp Dewalt drill have compared to a Ryobi 12-Volt drill?11 answersDoes a gas oven have the same wires as an electric oven to wire in ?10 answersIs there a pole device to sand a wooden deck manually?7 answersWhat amp drill do I need to bore holes in this stump?7 answersAttic door handle options?4 answers