I have a 1997 2wd 2.3 liter Ford Ranger and the front passenger side wheel was making loud noise and the wheel was pulling that way and I replaced the wheel bearing and a couple days later the same side is making that noise again and and pulling that way again. It has 4 brand new tires on it and the wheels aligned.
?
I hope you replaced the bearing race as well...If not, the race may have spun in the hub. I would just get a new rotor and hub assembly, and another set of bearings. Spend the extra dollar for some good grease, make sure you " pack " the bearings good.....And off you go.
Alex loves
make sure your brakes are bled properly then and check your ball joints by jacking the car up and grabing the tire at the 6 and 12 oclock angles and wiggle it up and down and do the same with the 3 and 9 oclock angles. if the tire wobbles then you need new jointss
Michael
It is possible that new bearings can go out that quickly, I would take the bearings back out and return them for warranty and inspect the spindle very closely.
valerie
Pre-owned vehicle with new tires
?
check brakes