90 300zx NA: slave cylinder?

Question

my clutch doesnt seem to grab very well. there isnt that point where the clutch grabs the transmission and the pedal is really soft. switching gears is a breeze and if i choose to burn out it all works but ive driven a number of sticks and this one is different you never really feel it grab the tranny you only know your in gear because when you step on the gas the car will take off. i took it to a mechanic and he said the master cylinder was fine so i should probably replace the slave cylinder though he wasnt possitive that that was going to solve the problem. what do you think? whats is going to cost for a new clutch kit and installation? what do you think the difficulty on installing a new clutch is?

Locomoco · Accepted Answer

http://gearsofwar.fanspeak.net/?C1918_528245

John Paul · Answer

Clutch job is 4.5 hours + clutch parts, exhaust system has to be removed . About $750 to $900 at the dealership. Four really good jackstands and a day or two you could do it if your clutch able. Things to replace while your in there Transmission mount any bad motor mounts drive shaft center support bearing and always resurface the flywheel replace the rear crankshaft seal. If you don't mind clutch leg put a performance clutch plate and lightened flywheel in while your there. but takes away from your of the line torque but adds quick throttle responce.

quick_ridez · Answer

A stock replacement clutch kit, should run anywhere from $70.00-$160.00. The slave cylinder will probably be anywhere from $12.00-$40.00. Keep in mind these are for bottom of the barrel parts, but they will be new. Labor will be from $50.00-$80.00 and hour, and I think it's about 4-5hours to replace the clutch.

Trending News

90 300zx NA: slave cylinder?

3 Answers