Anyone have a recipe for canning tomatoes?

water baths are fine for canned tomatoes

first dip your whole clean tomatoes in boiling water for about 30 seconds this is so you can peel them

after you have peeled the tomatoes put them in a bowl so the juice can gather add a little salt and what ever spices you like

place the tomatoes in clean hot canning jars fill the jars with the left over juice to within 1/2 in from the top( if you don't have enough juice you can use store bought tomato juice)

wipe edges of jar with clean wet rag put on lids and rings then cook in the water bath for around 30 min

remove the jars from the water and let cool on towell in counter if they are cooked properly the lids will pop inwards forming a seal if the jars don't seal properly do not eat them.

Tomato Soup

Try this website, http://www.canning-food-recipes.com/canning_tomato...

I used it when I canned my own tomatoes and everything turned out perfectly.

Here's one.

Traditionally, canning tomatoes has usually been done by using the hot water bath canner method.

Pressure canning is also required for many canned tomato combination products because the pH value is above 4.6 which is a low acidic food. Tomatoes themselves fall close to the low acid level, just slightly above 4.6 and when mixed with meat for sauces or with vegetables like peppers or zucchini, which are a low acidic food it raises the pH value above 4.6 and must be processed by pressure canning to insure food safety. Foods that have a pH value of 4.6, or lower, may be processed in a boiling water bath canner.

When canning tomatoes by themselves, it is recommended that acid should be added to lower the pH level. This can be done by adding 1 tablespoon of lemon juice or 1/4 teaspoon citric acid per pint of product. For quarts, add 2 tablespoons of lemon juice or 1/2 teaspoon citric acid. This may be done by adding directly to jars before filling.

Jars and Lids

---Lids---

Place jar lids in a small sauce pan filled with water and boil gently for 10 minutes before using. Do this before you need to place them on jars. Leave in hot water and remove as needed.

----Jars---

Sometimes recipes will say that it is not necessary to sterilize jars if they are to be packed with hot food. However, to be safe it is always a good idea. For preparing jars, wash them in hot soapy water and rinse well. Place in a large pot of water or water bath canner, and boil gently for 10 minutes. Leave in hot water until needed. Then remove a few jars at a time and place upside down to drain. They are ready to use in less than a minute.

Processing Methods

---Boiling Water Bath Canner---

Fill the kettle with the appropriate amount of hot water and begin heating it on the range. The water bath canner requires 1 to 2 inches of water above the tops of jars. This can be difficult to determine before the filled jars are in place but after a batch or two you will learn how much water you you have to add. It is always a good idea to have an extra small pot of water heating just in case.

Place jars on rack immediately after packing. Lower filled rack into canner. Jars should be covered by 1 to 2 inches of water. Add additional boiling water if needed. If you add more water, pour between jars and not directly on them (this is where the extra pot of heated water comes in handy). Cover pot with lid. When the water comes to a rolling boil, start to count the processing time. Reduce heat slightly and boil gently for the time recommended for the food being processed. When the cooking time is up, remove jars at once and place on a rack or on towels away from heat and away from any draft. Keep jars separated to allow for air space.

After jars have cooled, test for seal. To do this press down on the center of the lid. The lid should be con-caved and not move when pressed. Another method is to tap the lid with the bottom of a teaspoon. If the jar is sealed correctly, it will make a high-pitched sound. If it makes a dull sound it means the lid is not sealed or possibly that food is in contact with the underside of the lid.

When completely cool, the screw bands may be removed if desired but not necessary. Be sure to label canned jars with content and processing date. Store jars in a cool dark, dry place. If there is a possibility of freezing temperatures during storage, cover with a blanket or heavy cloth. Jars may also be placed in a box and stuffed with newspaper.

----Pressure Canner----

Follow manufactures instructions for opening and closing the pressure canner. Have 2 to 3 inches of hot water in pressure canner and stand the jars on the rack insert so they are not touching each other or the sides of the pot. Fasten lid and turn on heat. Steam, mixed with air, will start to flow from the vent and then This is about 8 to 10 minutes after the first sign of steam. As the air is driven out from the canner the steam will change from a white vapor or cloud to nearly invisible.

Start processing time when pressure has been reached or when weighted gauge begins to rock. It is then time to close the the pet-cock or regulator. Maintain a steady pressure during processing.

When processing time is up, remove the canner from heat and let the pressure return to zero without assistance. Standard heavy-walled canners take about 30 minutes when loaded with pints and about 45 minutes when loaded with quarts. Do not attempt to cool pot with cold water. This can cause liquid to escape from jars and keep lids from properly sealing. It can also cause pot warpage.

After pressure reaches zero, wait 2 minutes longer and then slowly open or remove the pet-cock or regulator. Unfasten cover and tilt the far side up so any steam remaining will escape away from you. Using a jar lifter, remove each jar and place on a dry, non-metallic surface or towel. Leave space between jars for air circulation.

After jars have cooled, test for seal and the screw bands may be removed if desired. Be sure to label canned jars with content and processing date. Store jars in a cool dark, dry place.

ENJOY :-)