Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and the Yahoo Answers website is now in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.

Anonymous
Anonymous asked in Home & GardenMaintenance & Repairs · 1 decade ago

My furnace is blowing out cold air?

Our power was out for 2 days. We had a generator and it worked the furnace, and it was all fine. The power came back on at 7 last night, we un-hooked the generator and went to bed. Woke up this morning and its 50degrees in my house. Followed the directions to re-light it perfectly, 3 times, nothing but cold air. It's a self lighting pilot, but I totally followed the directions. Is it broken? It's fairly new, HELP!!!

8 Answers

Relevance
  • 1 decade ago
    Favorite Answer

    The pilot is probably fine. There is a computer board that controls the furnace. It may have got damaged when you went back to regular power. You probably have to get the furnace company out to check it.

  • Julie
    Lv 4
    5 years ago

    If the green light turns to flashing red almost immediately then you have a tripped safety limit or other failure. Most likely a tripped limit but could be a number of failures. If it was an ignition sensing problem it would go through several attempts to light before going in to lockout unless it detected a open hot surface igniter. Since you have no experience with 'What's what on the inside' then you should have a tech come out. I hope your filters aren't plugged up.

  • Anonymous
    1 decade ago

    You know what would warm you up. An Orgy.

  • luka
    Lv 5
    1 decade ago

    did you disconnect the wires from your circuit breaker panel going to the furnace or shut off the breaker,if you did not when the power came back on you could of blown a fuse they are on top of the air handler about 5 amps they look like car fuses,check that fuse it might be blown.

    Source(s): hvac
  • DICK R
    Lv 5
    1 decade ago

    your golb pulg that light your frunce mit quit working. and you will need a new one it turn the gas on for your frunce . but before you go out and buy one . chack your wire to make sure know are lost. by moving the wire a little will tell you

    Source(s): .
  • Anonymous
    1 decade ago

    Maybe you need to warm it up. Say sweet and sexy things to it.

  • Anonymous
    1 decade ago

    I don't know.

  • 1 decade ago

    you need a new thermal coupler

    Hey DICKER???? WTF are you trying to say??? LMAO!

Still have questions? Get your answers by asking now.