Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.
Trending News
What Is The Torque Setting For A 2006 Chrysler Town & Country 3.3L?
Transmission Pan Bolts
3 Answers
- An AsteroidLv 41 decade agoFavorite Answer
It's 5-7 for nearly every transmission. Sounds low, but there's at least a dozen bolts in there so it will seal the gasket just fine.
- 1 decade ago
To Install:
Install a new filter and o-ring on the bottom of the valve body.
Clean and dry the oil pan and magnet.
Install the pan using Mopar® silicone adhesive sealant.
Tighten the oil pan bolts to 165 in. lbs. (19 Nm).
Add four quarts of Mopar® ATF+4 transmission fluid through the dipstick tube. Start the engine and idle for at least one minute. Then, with the brakes applied, move the selector lever momentarily to each position, ending in the park position.
Check the transmission fluid level and add just enough fluid to bring the level to 1/8 in. (3mm) below the lowest mark on the dipstick.
Recheck the fluid level after the transmission has reached normal operating temperature (180°F.).
Make sure that the dipstick is fully seated to prevent dirt from entering transmission.
