Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.
Trending News
Gas Central heating water pump noisy?
I've got a problem with my gas central heating, the water pump for the radiators is whining really loudly but only when the boiler is heating the water and it's pumping very hot water.
I've bled the system of air, there is already fernox system protector in the system (about 3 years old) and I've added this week Tower Triple X system silencer which seemed to quiet things down but only for a day.
Is there anything else I can try or is it time to replace the pump (which is about 7 years old, but apart from the noise is working fine).
If a replacement pump is required how much would you expect to pay for one fitted and to service the gas conventional boiler at the same time?
Thanks
I've also checked all the pipes it's not them banging or vibrating.
13 Answers
- Anonymous1 decade agoFavorite Answer
This can be due to 2 faults. Sounds like the pump bearings are worn, or you have a pocket of air circulating around the impellor of the pump. You may have an air vent on the pump to clear this, but if you have vent it with the boiler off. It is not difficult to change the pump yourself if venting air does not make a difference. There mmay be isolation valves on either side of the pump which you turn off with a sloted screwdriver, then undo the pump unions and wriggle it out. You will spill some water that is held in the pump doing this. If there are no isolation valves, then turn off the water supply to the boiiler and then remove the pump.A new pump will vary in price, depending on the type fitted. Average price is between £50/60. A charge for servicing varies depending on the Service schedule for the boiler, so get a quote before having it done. Good luck.
Source(s): Plumber UK. - ANFLv 71 decade ago
First answer given is very sound. In addition try turning down the boiler temperature. If the water temperature is too high as it enters the pump the water, due to the low pressure at the pump inlet turns to steam. This is know as cavitation. Only a small amount of water gets through and the pump can become noisey.
Secondly, if your have thermostatic radiator valves as a check put them all to fully open. If your heating water is very hot the valves will shut down and only allow a small flow through. This causes a whistling effect as the water is pushed through the smaller oriface. The pump could also be wearing.
Hope this helps
Source(s): Pump engineer dealing with domestic and large commercial heating systems. Now retired. - How do you think about the answers? You can sign in to vote the answer.
- Robert JLv 71 decade ago
It may be a faulty pump, but it could also be mechanical noise.
If the pump, pipes or valves are in contact with a hard surface, that may be working as a sounding board and amplifying the noise.
Make sure that neither the pump nor any pipework are directly in contact with wood or brick. If they are, get a roll of the felt style pipe insulation wrap (the stuff about 6" wide) and put folded pads of that under the pipework etc. - anywhere it touches a hard surface.
If you get any clicks or creaks from under the floor as the heating comes on or shuts down, adding a turn or two of felt around each pipe where they go through notches in joists will also reduce or cure that.
- 6 years ago
This Site Might Help You.
RE:
Gas Central heating water pump noisy?
I've got a problem with my gas central heating, the water pump for the radiators is whining really loudly but only when the boiler is heating the water and it's pumping very hot water.
I've bled the system of air, there is already fernox system protector in the system (about 3 years...
Source(s): gas central heating water pump noisy: https://biturl.im/GfaXS - Turdy malurdyLv 61 decade ago
To replace the pump with a Grundfoss,renew the pump valves if req'd and to service the boiler you wont get much change from £160,if any.
Phone a local Gas safe registered company,they might give you a quote over the phone.
- 1 decade ago
Is it a bell & gosset pump? I know some models have a clutch between the motor and the impeller of the pump..... the clutch looks like an X with 2 springs in it, some of the clutches look like a swirl (but these are really freakin old). It will create noise if this clutch is bad, and is cheaper than a whole new pump.
Bell & Gosset was the first brand to come to mind.....
- Anonymous5 years ago
If you are a beginner or have done some woodworking you will find these plans easy-to-follow as the instructions are very clearly written https://tr.im/79slO
The woodworking plans are straightforward so they are not complicated at all. Even if you are a total newcomer to woodworking you will simply be able to master all the techniques that are needed and the woodworking skills very quickly by following the concise and clear instructions.
Another thing which is so great about these woodworking plans is that there have been some videos included and there are some to guide you in how to build benches home furniture dog houses bird feeders sheds and much much more.
- TeresaLv 45 years ago
You have air in the system. All you need to do is get the air out. Depending on radiator types or the way the loops are run, there should be air vents in the system. Once you get t he air out, the boiler will quiet way down the the boiler wont cycle on and off so often. Also make sure the pressure is up in the system. Needs to be 12 or 15 pounds pressure in the system at start up. Look around for small vents on the radiators or piping to get the air out! Hope this helps! Good luck!!