How could you still lock your doors and open your trunk if you lost your keys and you get a push to start?

It wont push start unless the ignition is on, the steering lock will need to be broken to steer the car.

You will have to grab the steering wheel and turn with some force to break the lock.

Then you will either need to split the ignition barrel and push a small screwdriver inside the wired end and turn to start or run a live feed into the brown ecu wire then bridge the starter live or push start.

New steering lock =$$$$

New ignition barrel=$$$$

Cheaper to get it towed.

As for locking, you can lock from the inside then shut, but you will have to break back in again.

You can either bust the locks..=$$$$ to replace or use a thin piece of metal with a slight cut out pushed down the inside the frame and window to try and locate the locking mechanism rod.

if you can get a coat hanger between the door and window see if you can catch the lock on the door and unlock it. once your inside see if you can take the back seat out and crawl inside the trunk and pop the trunk.

unless you hot wire it or get a bit creative with the electrical, it is not going to happen. i have fired up a car with a single wire and a screw driver from the engine bay.

you may purchase the ignition tumbler cylinder with 2 keys on-line for lower than $25 yet keys received't have chip in them. answer: you want a bench grinder or rotary device to grind down the case of your previous IR key fob that got here connected to previous worn key. interior this fob is a small rectangular chip it truly is embedded contained in the case. Be very careful to no longer damage the circuit board for IR portion of fob because it is going to nevertheless artwork and may want to nicely be used back at the same time as pairing chip to motorized vehicle. Chip is black and is placed in route of the foremost blade end - it really is a separate piece it truly is molded into case so it is going to come out once you get rid of sufficient cloth. get rid of the circuit board and chip after eliminating sufficient cloth to allow basic eliminating. Chip can then be glued or taped to new key yet should be placed ideal to artwork. The chip should be as close to to ignition as obtainable in simple terms above key blade and oriented so as that it really is parallel to blade and laying flat. the different position and it received't artwork. follow pairing technique: using IR board with batteries held in position with tape you may element it at reflect and hit tiny button on board two times consecutively(once locks shows pink basic on reflect and two times unlocks shows eco-friendly basic on reflect. interior 30 seconds insert key into newly put in cylinder and turn to position 2 and anticipate 10 seconds. motor vehicle might want to start up yet when no longer attempt technique back. i tried putting chip in distinct places on key yet in person-friendly words had fulfillment at the same time as it develop into close to to ring surrounding cylinder and parallel - very troublesome and troublesome challenge. So the moral of the tale is patience and wondering outside field can avert lots of money and far misery particularly at the same time as coping with the stealership that does no longer allow you to recognize some thing except new key expenses $350 and new tumbler expenses $250