Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.

Lv 31,458 points

Adam T

Favorite Answers19%
Answers281

REALTOR in Rockford IL. with Prudential Crosby Real Estate. 27 year old male.

  • wire diagram for whelen m9000 light bar?

    I need help I boughta Whelen light bar and cant figure out which wires do what so far all I've found is the green is ground wire and hello positive for both alley lights but I don't know the take downs, front and back caution , and corner strobes

    1 AnswerMaintenance & Repairs7 years ago
  • p1400 . . . Make car lose transmission?? or be in nutural?

    ok here we go . . . I have a 97 ford explorer on my way home it lost all trans power. the motor would rev up just fine and didn't sound bad but car would not go. I sat with car running for 5 min. and then tried to drive it drove fine till it got to 30mph then tripped out again and went nowhere. another 5 min wait and same thing it went then didn't?????

    I have full trans fluid

    it didn't make any clunking or grinding noise

    code came up as p1400 - Differential Pressure Feedback Electronic sensor circuit low voltage

    everything i read has that sensor as part of the fuel system, but engine ran good??

    Could this part be the problem?? or is my trans toast???

  • 91 gmc 2500 doesnt seem to have the power to pull anymore?

    i got a truck it hasnt run in 2 years and I got it all up and running and fixed all the broken crap it sounds amazing but it just feels like it has drag to it like it doesnt have the power it used to i put it on the lift all wheels turn freely so its not a frozen caliper or anything

    HELP

    HELP

    1 AnswerGMC1 decade ago
  • 95 F250 squeeked now vibrates while slowing down coasting?

    I noticed some squeeking coming from the rear drive shaft area so i put wd-40 on everything ujoints and where it goes to trans and it stoped for a while

    now when coasting it seems to have a vibration to it

    need help any logical guesses?????

    2 AnswersMaintenance & Repairs1 decade ago
  • 97 ford explorer power window will not work?

    I have checked fuses they aer good

    I have replaced motor it is good

    the window still will not go up or down

    4 AnswersMaintenance & Repairs1 decade ago
  • 1997 ford explorer window will not roll up?

    i have checked all fuses and the motor runs what could be the problem

    4 AnswersFord1 decade ago
  • 97 ford explorer power window wont work?

    I have a 97 ford explorer with power windows the passanger window at first would only work some of the time now will not work at all from either the driver controls or passanger control. I can here the motor run sometimes in the down possition but not in the up possition.

    please help

    if you could also tell me where the part is located that is bad it would be a great help

    1 AnswerFord1 decade ago
  • how can i control the plantlife overtakeing the coral in my tank?

    ok i have a 55 gallon salt water tank with poloyp corals and some mushroom corals is their a way besides manually removing the plantlife (maidens hair and other alge life) to decrease the amount of plantlife in the tank

    it is over taking the corals and blocking their light

    i have a lot of $ invested in the tank and coral and dont want to end up loosing any

    fish in tank 2 clowns

    and 3 cardnials

    I might get a herbavor fish to try to battle this problem but was wondering if their was another way

    do you want to sugest a herbavor fish thats ok too

    8 AnswersFish1 decade ago
  • western conventional snow plow will not run motor?

    when trying to raise or angle the plow motor will not run the silinoid will click as it is susposto but the motor does nothing

    please help

    1 AnswerOther - Cars & Transportation1 decade ago
  • my washer will not go into spin cycle?

    i have a top loading washer and when i do a load of laundry it cycles through all the way until the spin cycle then it just turns off it doesnt whin or click or anhthing it just stops

    pease help

    5 AnswersMaintenance & Repairs1 decade ago
  • is there any grants available in illinois that a white male could get?

    I have started my own business and am trying to get a grant but i am a white male and all the grants are for minorites

    i cant afford a loan and i just need some capital

    please help

    2 AnswersOther - US Local Businesses1 decade ago
  • it is a problem with the wiring not battery or srarter or silinoid please help?

    this was my last question

    Truck might have bad battery BUT........?

    alright i tried to start my truck this morning it wouldnt start tried to turn over but wouldnt fire got jumped and it still tried but wouldnt fire then i took the keys out and shut it down and the truck was still trying to start whit no keys in it and ignition turned off then the jumpercables started smoking on the positive right at the battery and when i tool it off the cable was really hot i had positive to positive and neg to neg now the bat reeds 9.95 volts but wont even turn on lights or even click when trying to start need help please

    truck is a 91 gmc 3500

    now for the new question

    ok i have new batery and new starter i hook up neg on bat and when i hook up positive truck tries to start itself so I know it is something in the wiring between the ignition and the starter can you narrow it down so i dont have to do so much investigating????

    9 hours ago - 3 days left to answer.

    Additional Details

    9 hours ago

    starter silinoid is attached to the starter and is also brand new

    5 AnswersMaintenance & Repairs1 decade ago
  • not the bat or starter need help with wiring?

    this was my last question

    Truck might have bad battery BUT........?

    alright i tried to start my truck this morning it wouldnt start tried to turn over but wouldnt fire got jumped and it still tried but wouldnt fire then i took the keys out and shut it down and the truck was still trying to start whit no keys in it and ignition turned off then the jumpercables started smoking on the positive right at the battery and when i tool it off the cable was really hot i had positive to positive and neg to neg now the bat reeds 9.95 volts but wont even turn on lights or even click when trying to start need help please

    truck is a 91 gmc 3500

    now for the new question

    ok i have new batery and new starter i hook up neg on bat and when i hook up positive truck tries to start itself so I know it is something in the wiring between the ignition and the starter can you narrow it down so i dont have to do so much investigating????

    3 AnswersMaintenance & Repairs1 decade ago
  • truck might have bad battery BUT........?

    alright i tried to start my truck this morning it wouldnt start tried to turn over but wouldnt fire got jumped and it still tried but wouldnt fire then i took the keys out and shut it down and the truck was still trying to start whit no keys in it and ignition turned off then the jumpercables started smoking on the positive right at the battery and when i tool it off the cable was really hot i had positive to positive and neg to neg now the bat reeds 9.95 volts but wont even turn on lights or even click when trying to start need help please

    truck is a 91 gmc 3500

    5 AnswersMaintenance & Repairs1 decade ago
  • i think my truck has a bad battery but.........?

    alright i tried to start my truck this morning it wouldnt start tried to turn over but wouldnt fire got jumped and it still tried but wouldnt fire then i took the keys out and shut it down and the truck was still trying to start whit no keys in it and ignition turned off then the jumpercables started smoking on the positive right at the battery and when i tool it off the cable was really hot i had positive to positive and neg to neg now the bat reeds 9.95 volts but wont even turn on lights or even click when trying to start need help please

    3 AnswersMaintenance & Repairs1 decade ago
  • 4L80 transmission rebuild kit?

    i have a truck that the reverse has gone out i got quotes for 1800-1500 for a rebuilt not sure if they are talking about a new rebuilt or rebuilding this one but i found a rebuild kit on e-bay for 160 would this be the same if i bought this and took it to a mechanic to fix for cheeper??

    is there something different that a shop would do rather than my mechanic(who is good and has done other trans) with a kit i bought??

    2 AnswersMaintenance & Repairs1 decade ago
  • i need an illinois attorney (dba)?

    i have filed a dba with the state and got a tax number

    now this guy calls me and says the law has changed and you cant opperate under a dba anymore and you must be an inc. or llc or simmilar that the law changed as of febuary and if i dont file as a corporation or something that a $10000 fine will be issued

    the number he gave me has been disconnected

    was he fake or is this a real law

    3 AnswersLaw & Ethics1 decade ago
  • how do i get songs from the internet on to the i-pod???

    and where is the best site

    both cheepest

    and best variety with the most artist and songs

    2 AnswersMusic & Music Players1 decade ago