Kos

I switched my merc to mixing gas 50:1 rat.

I added a tad more oil

Due to oil in tank I couldn't drain.

It's not solid white. It's more like a weed wacker white hue kind of smoke.

Is this ok? Also IF the head gasket etc was shot. Would motor run if water was leaking into head? Ran motor in 55gal drum for 20 min. Ran fine. It's a 135 merc motor.

135 blackmax motor. Oil pump taken out. Black plastic shavings around metal gear. I'm guessing the gear is shot. What if any shavings left. Will it hurt anything in motor. I tried to get all of them out. Next the gas tank is full. I don't know how much gas Is in tank. It's a 1993 180 SEARAY. How do I mix the gas with oil. Any suggestions??

Oil alarm going off On a 135 merc motor.

If I disconnect the wires from oil res tank it still beeps. So I followed the wires from the warning mod to star-side of motor. Green. Brown. Purple. On the term block if I disconnect the brown from temp sending unit alarm stays on. But if I disconnect the brown wire from the warning mod the alarm stops. Also what's a easy way to check if the oil pump is working???

What is the easiest way to check to see if a oil pump is bad on a merc motor.

Oil is in reserve tank etc. Float works all is good. But I believe pump might be bad. Any easy way to Check and how???

In short 135 blackmax. Alarm is going off.

Beep beep beep. The warning mod was bad so I changed it. But low n behold it's still beeping.

The float on the oil-res tank is working correct.

Any ideas before I sink the boat?? Lol

If you want or can and your good at these problems email me.

kos101@yahoo.com

Thanks

In short 135 blackmax. Alarm is going off.

Beep beep beep. The warning mod was bad so I changed it. But low n behold it's still beeping.

The float on the oil-res tank is working correct.

Any ideas before I sink the boat?? Lol

If you want or can and your good at these problems email me.

kos101@yahoo.com

Thanks

I'm helping a friend anyway in short. It's a Searay boat with a 135blackmax Mercury engine.

When key is put in and turned on (Not started just turned on- It beeps 2 times showing the system is working etc)

But as soon as you start it. The alarm goes on- not a steady beep as if overheating. But a beep beep beep beep beep non stop. (note his boat is in the shade and no chance it was hot etc-just FYI)

The oil under rear seat is 60% full. On the motor the oil injection tank is 100% full and the float is moving freely.

So what would cause the alarm to go off as soon as you start the boat. And how to fix it or where to look for the problem. If it's a sensor (where is it and ca you jump it etc to see if it's a bad sensor?

I believe the motor is from 1993 mint cond. But I know for sure it's a 135 blackmax 2 stroke oil

injected system.

All wires on motor look perfect- Nothing is lose or corroded. You can eat off this motor.

Also 1 last ? What is the normal running temp for this motor? He has heard 140 to 190.

Thanks

Kos101@yahoo.com

I Know Fox has todays show but it dont show till 8 days after its been on TV. I had my TV set to record the whole show. But Someone who I wont say there name. I only got the 1st 30min of show and want to see the Rest of it. Does ANYONE know where I Can go on the web tonight and see the last 30 Min of the show??????????? Please help

Who sings the song Rain at the end of the show????

Does anyone know of a good site about the laws of workers comp in CA? I Have a friend that was fired while he was injured from his job. And he has been getting the shaft to say the least for 3yrs going on 4 now.

His Att- Says they cant fire him and they have to do this and that But he cant seem to get ANYTHING, Money beiing the biggest he is getting TD payments but thats it. Im hoping someone out there has had someone with the same problem or like it and knows a few things about workmans comp here in CA, if you want you could e-mail me

Kos

In a nut shell I took off the front cover of the timing belt and the belt looks like something is rubbing on it and makeing groves in it.

2nd I found to small ball bearings sitting behind the cover (What could those be from?)

3rd when you start th car the front cam pully makes noise (Semms like it is at least)

On the tension adjustment there is a tab that looks broke (Is a spring suposed to be there?)

The car only has 80000 miles on it.

It makes sound at a idle but when you drive it seems fine. But I know something is wrong.

Any Ideas???

I would really like to know what has ball bearings in that set up.

My side door will not lock 100% the electric lock unit has lost its kick. I have called BMW they want 224.00 Does anyone know of a online place with OEM parts that might have it cheaper??? If anyone out there is really good with BMWs Drop me a line if you would like to help me out with a few more problems.. Nothing big But it needs done

Thanks

I Need to help my son with a report. I Have found alot of sites but I cant find what Im looking for.

What I need is a copy (False or whatever) What a Dr would hand you with the info that you have cancer and all the numbers on your blood work and so On. Like a sample report. As if you looked at it you would think that he has cancer. He likes to do his reports as best he can And I Just cant seem to find that info. I can find info about what kind and treatment but not the reports. Anyone out there that can help me???? Report is due Monday. Thank You If need be you can e-mail me also

I Have a 1991 BMW 525I And for no reason at all the windows and locks quit working. Since they are electric locks I cant even use the key to get in the car. (I was able to get in the car though with the trusty coat hanger) Anyways above the ac/heatercontrols there is the computer or whatever it is that has the time MPG,AMPG,CODE, and so on there are about 10 buttons on it, The orange light for the back ground comes up but nothing in the display section. I Know that unit pops out But if it was bad can it cause these problems? All the fuses are good and the car runs great but I cant unlock the door or roll the windows down, I have taken the radio out and glove box and checked all the wires that I can from the pasanger side I would like to check under the drivers side but I can open the door. Any help Any Ideas?? If you need more info to help me just drop me a line

Im trying to find a good site about galbladder problems.

IE-Stones.

I would like to find a site that tells you about the galbladder and if you have problems what you can and cant eat. If there is anything you can do to make it better Anything like tis would help alot.

I have found small stuff But its only a page long and dont get into the whole food thing and the pain. Im trying to help a friend so I want to print it out also. Thanx alot

I Know most will be a Smart a** answer But I know this already so Answer it On what you think. My friend Is going out with a girl and she has been very stand offish lately. Anyways she has a few kids from her EX Husband. Now Her Ex's sisters kid Wants to go out with her. She is 36 he he just turned 22. Her kids call him uncle. Now even though they are not blood related per say. Do you think this is a good thing to do? I have asked her and she told me If she did it that it would only be for sex and thats it. She did kiss him and not a peck on the lips it was a KISS. She said I told him NO No this is a bad Idea. But she is still saying she is going to sleep with him. I think its wrong But my friend does not see it that way. Im wondering what anyone else thinks. I Know he loves her but I just dont understand.

He would like a song kinda sad but also tells her to F*** Off in a sence. Crazey ***** is ok but it says your a crazey ***** but then it says how bad he wants the sex etc. So if anyone has a good idea of a good song to play to her. To Tell her off in a way PLEASE LET ME KNOW. They were together for 5yrs and she just dumped him for her kids uncle (SICK BUT ANYWAY)

If anyone could help out real quick Im Helping a friend, Its a 1984 nissian maxima The timing says 8btdc On hood. I hooked up a time light and got it to 8btdc But the Smog shop says its way off. He keeps saying something has to be removed or disconected 1st then set the time. Can anyone tell me how to do it the correct way? Thanks Alot

Anyone know of a good Att in Sonoma County for a workers comp case or could help me in some way?

Or even E-Mail me @

kos101@yahoo.com

I have a friend who has a liver problem due to drug use. Even though it was a short time he used he is worried he might have hurt his liver is there anything you can buy or eat or do to make it better? (Note- He did not due hard drugs or anything like that if that matters) I have looked on the net for him but I cant seem to find any good sites with info or something I can print out fo him.. Thanks ALot