carguy0035

On Sunday the 6th I removed the dashboard of my durango to replace the heater core, now I have no pwer to hardly any of the fuses in the dash.

If I jump the #9 fuse in the dash to the hot battery - it will start, the fuel pump runs but no ligts, heat, etc....

Any idea wat I did wrong? everyting is pluygged back in where it came from and yet noting works like it should - wen I drove it into the garage it was a fine running truck now it is dead in the water

HELP it's my only vehicle

title says it all really if u need more info let me know I check several times per day

the airbox came loose while on a 18 mile ride and sucked sand into the airbox/carb/top end.

Stalling the engine

We got it home now, and pulled both plugs not to bad, drained oil flushed bottom end and refilled

pulled head drained coolant, cleaned cylinder walls, replaced pistons after cleaning.

Pulled both carbs and gave a chemical bath and rebuild to both

airbox is noe MOOSE and screwed in tight, moose filter as well

Now before I give it a kick - what did I miss

ONLY ANSWER IF YOU KNOW WHAT i MISSED

iF i'M GOOD TO KICK - SAY SO!

I set the file tab priority to high, force start, upload limit to 10% of download, copy peer list in properties, bandwidth allocation set to high.

The fastest download speed I can get from the trackers is about 4.0Kb/s

utorrent version: 1.8.2

I know it's an old one, thought the name was heavy metal - seems I am wrong-cant find it anywhere.

Lots of cool old rock music, it's a cartoon movie anyone know what I am talking about ???

Besides this one - dont be lame.

Dont clutter this with vulgarities, just a story or 2 -

best answer 5 stars !!!

Under the truck on the transfer case there are 2 wires green and yellow that are on a plug to the transfer case, also a stand alone brown wire.

I noticed a nearby harness with a connection and thats where the wires seem to have pulled away from, nowmy electronic 4x4 will not enguage, the motor still works, but will not light or lock in.

I need either a snapshot or a diagram of the wireing plug and what goes where.

Best and fastest answer gets the gold !!!!!!

I just remodeled the bathroom replaced all the old cast iron pipes with PVC sced 40 piping. (no leaks)

The system runs as follows:

Kitchen sink - to - washing machine - to the tub drain - then to the main outlet.

the toilet is running on it's own drain line to the main

the bathroom sink also runs on it's own line to the main.

there is only one vent pipe on the system and that is on the main just before it asses through the wall and out into the septic tank.

Now with that explained when the washing machine empties the wastewater it will either go into the tub or make the toilet gurgle, or both at the same time !!

I am needing to know that I do need to add another waste drain vent to this system, but where should it go??

Easiest spot would be outside the kitchen window from the sink before the washer, would that stop the backpressure and help the water not backup into the tub???

Best answer recieves 5 stars !!!!

leave a comment and I will edit !

I am watching it on speed channel right now!

Is anyone in florida?

when did this race take place???

I believe the original part of the home that I am working on was built around 1948 and the floor joists are logs about 6" in diameter they were rough sawn to about 4" on 2 sides only.

These logs are 16" on center and are resting on a basement wall without pressure treated sill.

I recently remodeled the above bathroom with a ceramic tile floor and 36" up the walls. I removed the cast tub and installed a fiberglass 1 piece unit. The floor and walls added a lot of weight to the floor joists, and I do not have room to sister anything or remove the logs.

I am wondering what is a good cheap method to keep the floor solid, and the grout from cracking over time due to the floor not being very stable.

The subfloor itself is 4 layers thick adding up to about 3-5/8", it does not squeak at all, and I used a cement backerboard for the tiles. 1/2"

I am in the process of tiling my bathroom, now that I have the 12 X 12 tiles on the floor and nearly done with them, I need to do the walls behind the toilet sink and cabinet.

My question is, how far do I have to move the toilet flange (pipe) forward so the new tiles will not interfere.

The toilet sits right on the wall. I used 1/2" backerboard, and I am using a 4x4 tile and thinset to mix and hold it together

The toilet tank was against the back wall tightly before I started this project. I had to replace subfloor and I installed 1/2" cement backerboard on the floor and walls.

I am using a 4x4 tile on the walls going 3" up from the floor. I need to know how much this will move the toilet forward so I know how much to cut from in front of the waste pipe so the toilet will have room when I go to re-install it in the next 2-3 days ( I hope)

I am in the process of tiling my bathroom, now that I have the 12 X 12 tiles on the floor and nearly done with them, I need to do the walls behind the toilet sink and cabinet.

My question is, how far do I have to move the toilet flange (pipe) forward so the new tiles will not interfere.

The toilet sits right on the wall. I used 1/2" backerboard, and I am using a 4x4 tile and thinset to mix and hold it together.

went to ultrasound and they said i had a grade to placenta and all they talked about was placenta previa

Dodgeman being the number 1 guy on here, I mean does he really work on cars or does he just sit in his mom's basement all day smoking cigars and looking up answers on Google, and pasting them for points???

I've read a lot of his answers and to be honest I dont know why he is #1

I rolled a 650 pound snowmobile and the handlebars got me in the ribs pretty good.

I went to the hospitol and the xrays said they are not broken or fractured, but badly bruised.

I was given oxycodone for pain, but at 430 thismorning I got woke up from a cough, I could barley move without moaning in pain.

I had to roll out of bed and move very slowly down the stairs, by the time I reached the bottom I was in tears from the pain.

Once there I pulled the string for the ceiling fan light in the kitchen, and I dropped to the floor in pain and layed there for a while.

My question is - are these pills not enough for the ain?

Is there anything I can do for relief?

heat or cold?

I might go back for a second set of xrays, I can barly move now. This is the worst that the pain has been.

PS - this happened Sunday night

a 403 forbidden notice when I answer a question?

It started after they did the update last night, and it dont always do it.

Does anyone else have this issue???

Seems that the felons would be the best to send?

With the BIG 3 going down - and no bailout relief, they will surley be closed, and send thousands to the unemployment line.

So are we all done?

Might as well leave now, avoid the rush!

BARACK =

The meaning of the name Barack is Blessed

The origin of the name Barack is African

Notes: Form of the Hebrew name Baruch.

Alternate spellings: Barrack, Barak

HUSSEIN=

The meaning of the name Hussein is Handsome One

The origin of the name Hussein is Arabic

Alternate spellings: None on file.

OBAMA=

The meaning of the name Obama is Slightly Bent

The origin of the name Obama is African

Notes: From a rare Luo (Kenyan) name, meaning a baby born with bent arm or leg or possibly a breech birth.

Alternate spellings: None on file.

And leave a link to a virus, or a malware, it's not like we have no protection from this.

Do they think they are going to get away with it?

Do they think they are funny?

Whats the deal, I've been on here for about 20 minutes now, and have found 6 links, with over 50 infections!!!!