stanly s

even though Im signed in on Y it won't let me change it to off

same for G, except no account there

bing too

Yes, I'm over 21 and have full privileges on this computer, but feel free to send ans. as message.

what's going on - seems like my viewing is hostage?

MS Sidewinder Precision 2 Joystick-Windows 7 recognizes it (also Win XP) and says it’s working correctly, but nothing happens. (Win says no driver files required or loaded) does Win saying it’s OK mean much?

[thanks Bob]

Additional Details

I can go through the calibration steps, when I try to select configuration either from the list (Sidewinder Precision 2 Joystick)or custom it says "your gameport or gameport driver are not properly configured. please consult device manager" .

Ther are 5 listing-3 for the joystick, they all say working properly including the one for the Precision 2 HID drivers.

Can I deduce from the fact that I can calibrate it that the joystick itself is working correctly?

Seems like that only leaves driver-where is a good source?

MS Sidewinder Precision 2 Joystick-I heard that windows support these and they are tough, so I found one and plugged it in. Windows 7 recognizes it and says it’s working correctly, but nothing happens. (Win says no driver files required or loaded) Do I need Updated drivers? The joystick is used so there is that too, does Win saying it’s OK mean much?

I've heard that a 84 civic and prelude have an external fuel pump.

What are the other years and where are these pumps located?

Is there a online resource that would show me a diagram of the location?

for a 12mm bolt- looking for both shear and side force deformation (permanent).

I'm sure there is a table someplace...

the local track says Must now have CE rated leathers, does this mean the leathers need to be CE or can i replace the armor with CE and and be OK?

WMRRA OMRRA and NESBA

I've got a LOT of these in my lawn, and would like to know how to get rid of them. Tried roundup and all it seems to do is kill the grass around them.

I found a reply about 4yrs old, BUT need something better than digging them out.

Thanks

lets make it interesting- missing lights and plastics

common problems?

thx

my brass fitting says Cali. finds that it may cause birth defects, mental prob. what's the story and what's in the fittings that they found?

I'm looking at used one (an 87 w/25k mi) and wondered if they had weak areas that cause problems.

saw these in store and it's so much smaller than my propane stove(1burner)-wonder how it compares? Any big downsides?

http://www.scientificutility.com/prod_heat.htm

How difficult is this + much will this cost (in shop hrs).

Is this beyond level of DIY (needs special and expensive tools, a special "touch", etc).

of approx same size of course, the downside of replacing a jacket zipper with a coiled one?

Stronger than metal zippers?

Even though I've heard that a different Lens is needed so the light doesn't scatter.

Seems like people must just put in the bulbs and ballast since the lens are all different shapes.

Is this a case of a halogen light Lens being the correct Lens or just all they can get so they go with it? Are there aftermarket lights w/ lenses intended for HID.

Now the wipers don't go to bottom of windshield when I turn them off . Have heard this may be either the motor or a controller? Where is the controller and what does it look like?

Yes, I feel embarassed to admit that I did this.

I'm looking at the coiled pocketsaws, anyone have experience with the different types?

The segmented wire vs braided wires types?

How long to cut say a 4" branch w/ each?

Coghlan's is a brand I've found in stores, are there others-better?

Link showing saws: http://www.coghlanscampinggear.com/coghlanstools.h...

Thax

PS: have segmented wire one that came in cheap survival knife - was unimpressed.

The situation:

I have a 95 Escort wagon that the rear springs have collapsed/broken on.

The wrecking yard has alternately said any 91-96 or any 93-96 spring interchanges-except Escort GT. ALL the wagons in wrecking yard have same problem as mine, so it would be good if there is a stiffer spring that

won't change my ride height.

The Ques: Which year range is correct? Will an Escort GT spring do what I want (have a pair of 91s at wrecking)? Is the spring from a 97 different? stiffer?

Thanx

an internet bike - guy says the o-rings are bad and it's sucking air. Making it run lean, it's some distance so I can't just run over for a look.

any cheap, easy temp fixes?

have a metal shovel for when snow is heavy, doesn't help when there is 1" wet snow stuck to bottom of shovel.

I'm thinking about buying one of these, it's high milage. ANY areas I should be sure to check out? Seller says it has intermitent crank position sensor.