FUEL HELP - Types of alcohal/gas - mixtures CNG, E85, Methanol - Lumina vfv fuel rail - AIR FUEL RATIO?

CNG has a ________ octane rating than gasoline and burns ________ than gasoline.
higher; faster
higher; slower
lower; faster
lower; slower
2. What is the typical air-fuel ratio of CNG-equipped vehicles?
18.0:1
16.5:1
12.0:1
14.7:1
3. Technician A says symptoms of exposure to methanol fuel occur immediately after exposure. Technician B says some symptoms may not occur for several hours after exposure. Which technician is correct?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B

4. Technician A says the Lumina VFV fuel rail is yellow anodized to make it impervious to methanol. Technician B says the aluminum fuel rail is lined with water resistant paint. Which technician is correct?
Technician A only
Technician B only

5.The energy content of methanol is approximately ________ that of gasoline:
60 percent
85 percent
25 percent
15 percent

6.Which of the following materials is LEAST affected by methanol?
Zinc
Aluminum
Rubber
Teflon

7.Compressed natural gas (CNG) is comprised mostly of:
Methanol
Butane
Methane
Ethanol

8.The fuel composition sensor measures:
ethanol percentage
fuel temperature
fuel density
Both A and B

9.Technician A says the operating resistance of Ford FF injectors is 2 ohms. Technician B says their resistance is 1 ohm. Which technician is correct?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B

10.Ford M85 fuel system pressure can be checked with a pressure tester that reads:
41 to 55 psi (284 to 376 kPa)
48 to 55 psi (333 to 376 kPa)
45 to 60 psi (310 to 415 kPa)
41 to 47 psi (284 to 325 kPa)

11.Technician A says that at the stoichiometric air-fuel ratio of 14.7 to 1, combined O2 and CO readings on a 4-gas analyzer should be approximately 14.7%. Technician B says that CO2 should be high and O2 should be low. Which technician is correct?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B

12.The GM variable fuel sensor also senses fuel:
Water content
Consumption
Percentage of alcahol
Flow

13.Which of the following devices prevents siphoning fuel from the tank of a VFV Lumina?
A check ball in the tank filler tube
An arrester in the filler hose
A fuel tank pressure vent valve
All of the above

14.The GM variable fuel sensor contains a variable capacitor and electronic circuitry to determine the percentage of:
Methanol
Water contamination
Unleaded gasoline
None of these

15.Technician A says the variable fuel sensor on a 1992 Lumina VFV is removed by disconnecting the threaded hose fittings. Technician B says the variable fuel sensor on a 1991 Lumina VFV is removed by using the quick-connect fittings. Which technician is correct?
Technician A only
Technician B only
Both Technicians A and B
Neither Technician A nor B

Anonymous2009-02-18T19:23:55Z

Favorite Answer

Yes. You should make sure the intake valves are seated, exahaust valves are rarely a problem. I usally put peanut butter on anything that is leaking. Good luck. I hope this helps.

halyard2016-12-24T20:59:09Z

truthfully motorcycles do like alcohol. I had an '80 one CB750 custom and each spring i could pour a bottle of isopropyl alcohol interior the gas tank and take it for an prolonged journey. I on no account had to have the carburetors re-worked because of the fact of gumming. I did a similar to a pair different motorcycles that I even have owned.