Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.

FUEL HELP - Types of alcohal/gas - mixtures CNG, E85, Methanol - Lumina vfv fuel rail - AIR FUEL RATIO?

CNG has a ________ octane rating than gasoline and burns ________ than gasoline.

higher; faster

higher; slower

lower; faster

lower; slower

2. What is the typical air-fuel ratio of CNG-equipped vehicles?

18.0:1

16.5:1

12.0:1

14.7:1

3. Technician A says symptoms of exposure to methanol fuel occur immediately after exposure. Technician B says some symptoms may not occur for several hours after exposure. Which technician is correct?

Technician A only

Technician B only

Both Technicians A and B

Neither Technician A nor B

4. Technician A says the Lumina VFV fuel rail is yellow anodized to make it impervious to methanol. Technician B says the aluminum fuel rail is lined with water resistant paint. Which technician is correct?

Technician A only

Technician B only

5.The energy content of methanol is approximately ________ that of gasoline:

60 percent

85 percent

25 percent

15 percent

6.Which of the following materials is LEAST affected by methanol?

Zinc

Aluminum

Rubber

Teflon

7.Compressed natural gas (CNG) is comprised mostly of:

Methanol

Butane

Methane

Ethanol

8.The fuel composition sensor measures:

ethanol percentage

fuel temperature

fuel density

Both A and B

9.Technician A says the operating resistance of Ford FF injectors is 2 ohms. Technician B says their resistance is 1 ohm. Which technician is correct?

Technician A only

Technician B only

Both Technicians A and B

Neither Technician A nor B

10.Ford M85 fuel system pressure can be checked with a pressure tester that reads:

41 to 55 psi (284 to 376 kPa)

48 to 55 psi (333 to 376 kPa)

45 to 60 psi (310 to 415 kPa)

41 to 47 psi (284 to 325 kPa)

11.Technician A says that at the stoichiometric air-fuel ratio of 14.7 to 1, combined O2 and CO readings on a 4-gas analyzer should be approximately 14.7%. Technician B says that CO2 should be high and O2 should be low. Which technician is correct?

Technician A only

Technician B only

Both Technicians A and B

Neither Technician A nor B

12.The GM variable fuel sensor also senses fuel:

Water content

Consumption

Percentage of alcahol

Flow

13.Which of the following devices prevents siphoning fuel from the tank of a VFV Lumina?

A check ball in the tank filler tube

An arrester in the filler hose

A fuel tank pressure vent valve

All of the above

14.The GM variable fuel sensor contains a variable capacitor and electronic circuitry to determine the percentage of:

Methanol

Water contamination

Unleaded gasoline

None of these

15.Technician A says the variable fuel sensor on a 1992 Lumina VFV is removed by disconnecting the threaded hose fittings. Technician B says the variable fuel sensor on a 1991 Lumina VFV is removed by using the quick-connect fittings. Which technician is correct?

Technician A only

Technician B only

Both Technicians A and B

Neither Technician A nor B

2 Answers

Relevance
  • Anonymous
    1 decade ago
    Favorite Answer

    Yes. You should make sure the intake valves are seated, exahaust valves are rarely a problem. I usally put peanut butter on anything that is leaking. Good luck. I hope this helps.

  • 4 years ago

    truthfully motorcycles do like alcohol. I had an '80 one CB750 custom and each spring i could pour a bottle of isopropyl alcohol interior the gas tank and take it for an prolonged journey. I on no account had to have the carburetors re-worked because of the fact of gumming. I did a similar to a pair different motorcycles that I even have owned.

Still have questions? Get your answers by asking now.