Desktop hangs at Verifying DMI Pool Data?

DMI or DesktopManagement Interface (pdf) is a layer of abstraction between system components and the software that manages them. The System Management BIOS (SMBIOS) is an extension of the Basic Input Output System (BIOS) that formulates and delivers this information to the operating system. The pool data is the information. In short, when the BIOS is "Verifying DMI pool data" it is verifying the table of data it sends to the operating system (Windows, etc.). If it isn't sucessful, it should return an error. Wait a reasonable period of time for it to finish. It may make take some time or it may be stuck. Possible fixes:

1. If you changed the hardware just before this problem occurred (e.g., installed a new hard disk drive), unchange it.

2. If you installed a new hard disk drive, set the motherboard CMOS Setup to Auto for the drive type. You may have to disconnect the drive first.

3. Enable "Reset Configuration Data" (may be "Force Update ESCD" in some CMOS Setuups) in the motherboard CMOS Setup PNP/PCI configuration. (Rebooting will automatically disabled it after it has done its thing.)

4. The CMOS may be corrupted. Clear it.

5. Disconnect all drives not required to boot the computer. If this fixes it, reconnect one at time.

6. The floppy drive may be bad or not connected properly.

7. Reseat all expansion boards.

8. Pull all boards not required to boot the computer.

This sounds like a hardware problem. Get your RAM and Motherboard checked. Simpler to call in a hardware technician and sort it out. But you may want to check the instructions at this link first: http://www.duxcw.com/faq/computer/dmi.html

Try the following links:

http://www.computerhope.com/issues/ch000474.htm

http://www.duxcw.com/faq/computer/dmi.html