A seemingly simple problem with toilet flapper?

look closely at the flapper attachment spot. You might need to turn it a tiny bit, or find a way to lift the underspot to raise the angle, resulting in a rearward shift of the flapper surface. If it has small bolts holding the flapper to the mounting device, you can try slipping a couple of small washers under the flapper fabric to raise the angle.

Tilting or shifting the fill pipe, where the flapper is usually attached to, can be tried, albeit very gently. I hate having to replace those! the lower seal can get good bit wonky

As a last ditch effort, shut off the water, drain the tank (flush) ang break out the hair dryer. Warm the flapper ball gently so that it is softer than usual, and then press it onto the drain ring.

DO be careful not to electrocute yourself, make sure you are using a grounded appliance in a GFCI recepticle, and everything is dry first!

This is like re-shaping the gasket on the fridge when the seal starts to get older and lets air pass.

it extremely is an undemanding undertaking with replaced flappers. it extremely is commonly no longer undemanding to appreciate why it happens. What you're able to do is set up something that limits how far the flapper opens, shop it decrease than "today up" with a end of a few form. yet then you certainly could could desire to hold the lever for a good flush.

You might have gotten a flapper that was close but not identical. Go back and try a different one.

u got the wrong flapper they all look the same but are different garanteed

If it's very close, you should be able to push on the tube a little bit and it will seal.