Help with my Biology homework, please?

The problem is if the specimen is too transparent you won't be able to see anything!

You use then a "stain" this stains the specimen and shows different structures as different colours allowing you to see it better.

Stains can be found here - http://en.wikipedia.org/wiki/Staining#Common_biolo...

How to stain follows:

1

Prepare a wet mount slide as you normally would.

2

Use an eyedropper to collect a drop or two of your stain from its bottle.

3

Place a single drop of stain on the outer edge of the cover slip on top of your slide. You can place the stain on either edge of the two ends of the cover slip.

4

Tear off a small piece of a paper towel. Set the paper towel against the opposite end of the cover slip, as close to the edge as possible. The paper towel will act as a magnet, pulling the stain underneath the cover slip.

5

Wait until all of the stain has been pulled in between the cover slip and the slide. The stain should completely cover the specimen on the slide. If it does not, add another drop of stain to the edge of the cover slip.

6

Remove the piece of paper towel and place the slide on the viewing tray of the microscope.

7

Clean the slide and cover slip when you are finished examining the specimen. This must be done gently, as cover slips are quite fragile. Use warm, soapy water and allow everything to air dry. Make sure all the stain has been removed before putting the slide and cover slip away.

What can i do to make it easier to see a specimen that is very thin and transparent?