Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.
Trending News
sealing header to block without bolts?
I pretty much know the answer, but just want to see if someone has an idea/tip or something.
I own an 86 El Camino. I did an engine swap and took out the small block 305. Then I put in a 402(396) into my El Camino. My exhaust broke in a few spots. When it broke it snapped the header bolt closest to the firewall. As it sits now it is pretty much impossible to extract the broken bolt unless you pull half the engine out to even get something like an ez out to it.
So my question is there another way you can seal a header to the block that does not require a bolt?
6 Answers
- mobile mikeLv 67 years ago
Some headers are hard to seal even with all of the bolts.You'll need to pull the head.At this point there are no shortcuts.I might consider a stud(s).I've done this swap on an '85.Hooker makes a very nice set of super competion headers just for this swap.I use the original metal manifold gaskets coated with Ultra copper silicone with good results.
- HarryLv 77 years ago
bad deal, center punch, reverse drill and tap if needed. if you cant use a right angle drill, pull it. welding will not work without also heating the head with a rosebud before you try to turn it. its to much heat on that cast.
been there, done that, used one wrong bolt on a 302 intake. it snapped, had to remove the intake. a good welder may be able to weld a stud in place, but it needs heat treated after or it wont be strong enough.
2-4 hrs to pull the engine and then its on the bench, good time to reseal crank, pan, new timing chain, and some chevy orange
- RolomaticLv 67 years ago
It's probably easier to pull the head off and drill the broken manifold stud out on the bench then it would be to pull the entire engine. (no easy fix for that conundrum)
- How do you think about the answers? You can sign in to vote the answer.
- bobLv 77 years ago
Pull the head, and have the bolt welded out. I don't remember EVER having an EZ out work for me. If you weld a washer to the bolt, then weld a nut to the washer, the bolt will come out easily, every time, most times you can turn it out with your fingers.
