Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and beginning April 20th, 2021 (Eastern Time) the Yahoo Answers website will be in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.
Trending News
Riding lawn mowers blades
I have a riding lawn mower that is destroying my grass. As you know riding lawn mowers have different level as to how high you want to cut your grass, normally I would cut my grass at level 2, but now level 2 is destroying the lawn. So i had to move the blade lever from level 2 to level 4. So my question is---is buying a new blade for my riding lawn mower will find this problem.
7 Answers
- burning brightlyLv 71 decade agoFavorite Answer
It may fix the problem you just may have struck a stone with the blades and they are slightly bent downwards .~~
- TedruskiLv 61 decade ago
Don't pay any attention to what number or level it says on the mower. Set it for how high you want it to cut by doing a test cut. Many things can affect the mowing height. Air pressure in tires too low, yeah you got it your deck goes lower also.
You may need to take a scraper to the underside of the deck to get off all the compacted grass. If this collects too much it stops the discharge grass from getting thrown out.
Check your deck roller wheels to see if they are bent or missing. these wheels keep the deck from scalping the lawn.
One or more blades may be bent also.
Source(s): I have mowed 4 acres for 20 yrs. Went through several riding mowers - 5 years ago
i agree with garylee. you should immediately stop using the blades. i'm surprised you haven't burned the belt out. you can try squirting WD40 into the area above the blade housing to see it it may loosen that blade up. also squirt the wd40 (buy at any hardware store) it's used to loosen rusted parts. give it a good squirt from the top not from underneath the mower. that one bearing is rusted and sitting over the winter didn't help it any. each one of those units can be replaced separately. after squirting let the mower sit for a day or two. try moving the stuck blade before restarting the motor. remember to disconnect the spark plug or battery cables so the motor can't start up while you're turning the blade by hand. always keep that hint in mind when turning any mower blade by hand. good luck to ya
- TomcatLv 61 decade ago
It sounds like the deck is unlevel in which case replacing the blade will not help. On craftsmans mowers the owners manual details how to make this adjustment. It's basically measuring the front and rear deck height and adjusting it to be level side to side with the front maybe 3/4 inch lower then the rear. Something of that nature. Also remember low air pressures can affect cutting height.
- How do you think about the answers? You can sign in to vote the answer.
- 1 decade ago
There are a number of reasons why you may be having this problem. If you have bent your blade(s) then obviously, replacing them will help. You may also have an issue with your cutting deck. Lift your deck to the highest cutting level and visually inspect your blades. If you have made an adjustment from levels 2 to 4 than there should be a significant bend in one or more of your blades (which you should be able to easily identify with a visual inspection).
Source(s): I work for a Lawnmower Retailer. - 1 decade ago
you will find out the resolve for this problaem at http://lawn-id.blogspot.com/
thanks - http://www.asesidea.com/