?

I have an 06 HHR manual transmission and my instrument cluster is damaged. I am looking to replace it however I am wondering If its a direct swap or does it need to be programmed with the vin. Also is the mileage stored in the computer or the cluster itself. will my odometer reading still be the same or will it change to the donor vehicles mileage reading?? IF it needs to be programmed with the vin will that take care of the mileage or is a separate issue?

91 ford explorer. From my experience i believe its the lifter that are ticking. The ticking only occurs during the first or cold start up. the noise will go on for about 40 secs and then stop. can anyone tell me exactly what it is, why does it occur? can it stopped/repaired and how? if unattended what will it lead to? Thank you...

I have a 1993 toyota pickup

2.4L 4cyl fuel injected

automatic column shifter.

Does this year truck come with a floor shifter automatic or only a column shifter automatic?

Does this year truck come with a carburetor or only fuel injected?

Just did an auto to std swap. The mechanic didn't thighten the shifter and while driving it popped out. Since I was on the road i tried to put it back in and played with it trying to get it into gear. I believe I stuck it into two gears at the same time since even in neutral it would go forward and 1st seemed to be 3rd or higher. Went to garage and the mechanic just inserted a long screwdriver where the shifter goes and applied pressure a couples time and got it into neural. Charged me 50bucks for 5 mins. I just would want to know what he did in the trans to get it into neutral and unstuck out of the two gears since I tried for hours on the road?

Will the head lights, front bumper and grill from a 2004 xterra fit on a 2001 xterra.. with out major modifications for it to fit?? will the headlights alone fit? or will the headlights and grill fit if i use the same 2001 xterra??

I am constructing a 36' x 46' gable roof. I am considering of going all steel rather than timber. I'm using "c" channel steel for rafters and purl ins and zinc coated metal sheet on top. My concern is how many feet apart from each other should the rafters be placed? What type of trusses to weld? Over all will the steel outlast the lumber by a huge number of years? In this location there is no snow, no salt water and mostly hot climate and a few months of rainy season.

97 s10 2.2l 157k miles. 1st mech. Changed comp. box and stil. he den sent me 2 an electrician who said injector wires were shorting. Sameting again 3rd mech changed 4 injectors an regulator and sameting again. Cld d box b damaged again? Or did dey miss someting? Hve been to 3 mechanics spent over 1500 and still cant get it fixed.? Need urgent help pls anyone.

97 s10 4cyl 2.2l. Recently did a trans swap. Converted from auto to manual since then i've been having very high reving especially when pressing the clutch and changing gears. This high reving also occurs when the engine just started to matter how hot the engine is. it will still rev high. I have already changed the TPS and Air control sensor, Coolant Temp Sensor and the problem still exists.

Will the compressor be a perfect fit in regards to bolt pattern and hose connections? Or am i just wasting my time?

97 chevy s10, 4cyl 2.2. 5 speed trans. Everytime I start it will idle high for about 15 secs then go down to normal. Everytime i shift gears it will idle high even though i am pressing on the cluth. When slowing down it will idle high until i come to a complete stop and remain parked for about 15 secs.