?

Have a 94 gm 3800 V6 that likes to stall and may or may not restart. So I replaced ignition, cam shaft sensor, harmonic balancer and numerous other items chasing codes. On a hunch I replaced fuel filter (improved) and then fuel pressure regulator. Following that, I now have difficulty starting the car. Any ideas?

P.S. The car only has 95k on motor.

I understand the 3.0 l had sludge problems pre-2002 if the oil wasn't changed religiously but the 3.3 l didn't have as long as a service life. What are your thoughts?

I have a older XP laptop that blue-screens while booting and restarts. The code it provides is as follows: 0x000000ed (0x859082d0, 0xc0000009a, 0x00000000, 0x00000000). I've pulled ram chips and tried single chips with same result. Also, I've tried changing bios boot-sequence numerous times using both a boot-able usb and windows 7 cd but it will not launch a new install either way. Additionally I've tried every boot with options (f8) with same results. Any ideas on diagnosis?

The blower stopped working on all settings. I didn't experience the resistor symptom of working on some settings and not others it was either all or nothing. I did experience hitting bumps in road and suddenly working again but now nothing works. Any ideas as to which component is likely bad?

Thanks 8-)

I added refrigerant to my AC Unit. My AC Clutch kicks in and out intermittently. I bypassed relay and clutch will stay engaged so its not the cluch.Also, When clutch kicks in my pressure drops. Any ideas what I check next?

I have a 18 by 22 patio (with foundation perimeter) that I've planned on building a room addition on. I have the opportunity to purchase a 19' by 25' used walk in freezer($1000) that I was considering using as the rooms frame work. The panel widths are such that I could reduce the rooms footprint slightly to accommodate perimeter facelift (veneer).

Would this be a viable alternative to framing a room. What are your thoughts?

I have a room addition that is not serviced by my floor registers (Slab on Grade). I would like to service the room via my attic using insulated flex duct but I'm not sure how or where on my furnace I would add the duct.

Is this even possible given my furnace feeds immediately into my slab-on-grade floor vents and also If I do tap into furnace adjacent to vent system would or can it adversely affect the rest of my house?

I recently came in to a large load of Commercial Insulation (demolition) and am going to place over my thinly placed Cellulose Insulation between Wood Joists overlying my drywall Ceiling .

If I place the Insulation with the Vinyl side up does any one think there might be a trapped moisture problem?

Replaced thermostat this weekend (180 degrees vs. 190 rec'd) because engine was overheating. The overflow fluid is lukewarm while overheating however temperature gauge is on redline-hot and is boiling at the radiator fill cap. Upon sitting while cooling, the main feed hose (at thermostat) collapses. The antifreeze is old and looks rusty but don't believe it is problem as this happened all at once. Also, no leaks at the water pump and I have heat. Any ideas for my next approach on diagnosis?

Thanks for any input

We were offered to buy a Russian SKS (WW2 Era) in decent condition. We have little knowledge about the gun, but knowing it's Russian we'll probably get mixed answers. But here goes.

$235 for the gun in good condition, and 100 rounds of ammo. Anyone know if this is a good deal?

We're in the market for a relatively cheap defense rifle, which is why we were offered. If you have any other ideas, feel free to mention it.