Michael Larson

it seems to shift too early some times around 2nd and third gear. and created a vibration from the engine until it can pick up again. i know previous dakotas had a tv cable but i could not find it on my dakota. how would i adjust this?

i have a 05 dodge Dakota that has the 4.7l. at startup it has some nastly lifter noise and developed a valve knock on start up and as soon as it warms up for about 1.5 minutes the car is silent it runs completely fine. the oil light also pops up when it starts as well. i has a oil leak coming out of the cranks shaft seal in which im going to fix tomorrow. it kind of seams like either the engine is losing vauum from the cranks shaft seal and causing poor vaccuum on start up or the oil pump is failing. i have yet to drive it for the last 4 days encase something goes bad and im out of a vehicle.

every time i turn my 05 dodge dakota 4.7 on after its been sitting fro a while you can here noticeable lifter noise. as soon as it warms up its gone. also the oil light will turn on but will go off as soon as i turn the car on and off again. im thinking its the oil pump failing. and you can here a noticeable whine at speeds when you even out the speed. i just dont get the truck everything just seems to keep failing.

i drank a large tim hortons hot chocolate and i started to get chest pains. its happend for the last week. i have a blood glucose meter as my dog has diabetes and it a contour usb. i checked my level at its at 5.7 after drinking the hot chocolate. i have not eaten anything today.

i have a house sort of like this

http://www.homeequitycalifornia.com/wp-content/upl...

and on the peek of the house there is no eavestrough to attach the bulbs to. but over the garage there is a eavestrough in which i have attached those clips to. how would i get lights up there without putting any holes in the roof

i have a house sort of like this

http://www.homeequitycalifornia.com/wp-content/upl...

and on the peek of the house there is no eavestrough to attach the bulbs to. but over the garage there is a eavestrough in which i have attached those clips to. how would i get lights up there without putting any holes in the roof

have a 550 series brigs and straton. just replaced the magneto coil, carb on the gs tank as well as the gaskets and diaphragm. replaced and gaped the black and gas smelling spark plugged. replaced and oiled the air filter. removed checked the fly wheel key nothing. replaced the oil with new synthetic. tried to run it. it ignited after several cranks for just 1/4 a sec. checked the oil level is fine but now reaks of gas again and the spark plug is wet with gas again. when it did run two weeks ago it maxed out its rpm and had to shut it off.

any ideas

have a 550 series rigs and straton. just replaced the magneto coil, carb on the gs tank as well as the gaskets and diaphragm. replaced and gaped the black and gas smelling spark plugged. replaced and oiled the air filter. removed checked the fly wheel key nothing. replaced the oil with new synthetic. tried to run it. it ignited after several cranks for just 1/4 a sec. checked the oil level is fine but now reaks of gas again and the spark plug is wet with gas again. when it did run two weeks ago it maxed out its rpm and had to shut it off.

any ideas

its from 2008 craftsmen lawnmower with a 5.5 brigs engine on it. it has the diaphragm carb on top of the tank.

i bought it off of a guy who said it did not run. he replaced the mag coil and spark plug and nothing. i found the carb sticking and the gaskets leaking so i replaced the carb and the gaskets plus changed the oil because it smelled like gas. after that still have nothing.

any ideas

its from 2008 craftsmen lawnmower with a 5.5 brigs engine on it. it has the diaphragm carb on top of the tank.

i bought it off of a guy who said it did not run. he replaced the mag coil and spark plug and nothing. i found the carb sticking and the gaskets leaking so i replaced the carb and the gaskets plus changed the il because it smelled like gas. after that still have nothing.

any ideas

i was eating sunflower seeds with the shells on as i usually do and the next day i feel like i have something stuck in between it. there is no pain and i have tried brushing, flossing, saltwater and a toothpick but nothing is working. when i floss nothing comes out just a bit of blood from trying to dig it out. any ideas?

i bought a la aurora sublime cigar yesterday so its an ok cigar. anyways i am on my way to a Canada festival in my home town and i have no cutter and no knife on me. i completely forgot to bring the cutter. any ideas on how to cut it?

just bought the one with the LCD and it does not turn off without unplugging it. the blue lcd and blue water light and it is always on. any way to turn off the lcd and water tank blue light?

i have about id say 15 devices that need to be hooked up to it. my dir 655 just went caput after 6 years. i don't need a ac router that is for sure but im looking into less than 120$ before taxes maybe as high as 140$ but that would be my limit. i do not like linksys routers and refuse to buy them.

this is the one im thinking of getting http://www.bestbuy.ca/en-CA/product/d-li%E2%80%A6

these are the places in which i can get them.

www.bestbuy.ca

www.futureshop.ca

http://www.canadacomputers.com/

i have about id say 15 devices that need to be hooked up to it. my dir 655 just went caput after 6 years. i don't need a ac router that is for sure but im looking into less than 120$ before taxes maybe as high as 140$ but that would be my limit. i do not like linksys routers and refuse to buy them.

this is the one im thinking of getting http://www.bestbuy.ca/en-CA/product/d-link-d-link-...

these are the places in which i can get them.

www.bestbuy.ca

www.futureshop.ca

http://www.canadacomputers.com/

i got my adenoids removed on Wednesday and everything went well. throat feels fine. no blood and sinuses are starting to clear. one problem i do have is i am so dam tired all the time. so far my day has been this. i have slept from 10:30 last night all the way to 930 this morning. i was up ate some food then felt incredibly tired and went back to sleep at 1030 and got up at 1230. i still feal as if i could sleep another 5-6 hours but i have to do some things in half an hour. on Friday i went to bed at 430pm and did not get up till 8am the next morning. and then had naps throughout the day. i just don't get it. i have to work tomorrow and start a 9 hour shift again to make up for the time i missed, but im not sure if i can do it as its physically demanding. .is this normal? any tips in keeping my self awake?

any help would be great

it is going to run out in june and if i get a new 1 year membership. does it go onto the new xbox when it comes out or should i just get a 3 month because i already have a 1 month as well.

I had my adenoids removed and I've been taking them for pain every 4 hours since Wednesday at 5 and they have given me absolutely no pain reduction. It took me thirty minutes to swallow two spoon fulls of mashed potatoes yesterday. My throat it absolutely killing me. All these pill do is make me very tired . That is about it. Can I take an Advil with it or what?

So I made a cutting board but have not finished it as I don't know what to use on it. I want to bring out the grain in the maple and walnut without the maple going yellow over time. What should I use and how should I apply it. http://i.imgur.com/iPEIAdm.jpg

Is it still good. No flakes on the bottom.